Wow - surprise, surprise you don’t need an
expensive printer to print labels on fabric. A while ago I used this technique to print labels on
fabric, using a "Brother" Laser Printer and a "Canon" Inkjet
printer. Both printers worked for me with no problems.
These labels are washable,
but the ink on the label may fade in time, so to stop this from
happening I needed to make sure I heat set the ink, I have also embroidered the
writing with thread.
What you will need
A printer (Laser or Inkjet).
Ink.
100% cotton fabric works best.
Freezer paper to stabilize the fabric (makes the bonded fabric)
An iron and ironing board
Cut a piece of freezer paper to about 9 x 12 inches. Iron waxy side of freezer paper securely to the back of your fabric. This will give you a stiff sheet of fabric that you can feed into your printer. Trim your bonded fabric to an exact 8.5 x 11, make sure there are no loose threads or unsecured edges to catch in your printer, because the fabric is now stabilized with freezer paper, it will roll through the printer without any problem.
Carefully feed the bonded
fabric into your printer like you would if you were doing a single sheet feed
of paper, positioning it so that when it feeds through the printer the label
information will print onto the fabric (whether the fabric is right side up or
down will depend on how you normally feed your paper into your printer).
You can make a simple label
using any text programme in Word, centre and type any information you want to appear
on the label just enjoy yourself and have fun playing with WordArt, ClipArt,
Fonts, etc. Remember to allow space around your label graphics for the ¼" seam
allowances.
Select paper size Letter
8.5 x 11 then hit print on your computer.
Carefully remove the
printed fabric (label) to the ironing board, and peel off the freezer paper,
with your hottest dry iron setting, making sure you place a scrap of cloth or extra blank sheets of paper
between the ink on the label and the iron and ironing board to catch any wet
ink, heat set the ink to the fabric for a few minutes.
Soak the label in hot water
to check that the ink has been set to the fabric, dry the label on a flat
surface and iron it again using starch, turn over the edges approximately ¼"
and press, ta da the label is ready to be stitched onto your quilt.
WARNING: There is always
the potential risk of damage to your printer. While many printers are
adjustable for thicknesses of paper, the manufacturers generally do not approve
of you putting fabric into them, and you may void your warranty!!!! I give no
guarantee that this process will work on your printer but I took the risk and
had no problems with my printers
If you do try this remember to make a test sample
first.
 |
|
This label's writing was also appliqued with variegated thread.
|
Until next time happy quilting.
Anne
